I have not been able to find a drain bolt gasket (crush washer) that fits my 86. I tried Toyota, Autozone, and other local auto part stores. I found a copper one that seemed to cover the contact area but now I have a small leak. Where do you guys get your drain bolt gaskets?

Stock oil pan and still using OEM spec M12xP1.25 drain plug correct?
When I reside in SoCal, I acquired at the all places that you mentioned.
I would NEVER take my car to your local Toyota dealer...since it seems like they cannot do simple oil change...

JFYI, below is the OEM part # that fits M12 drain plug.

Theres another oem one that works too. Its black and I believe made out of hard rubber. (It's shown in the parts diagram for ae86.) I don't remember part #...

However, the the blue ones ae86kai posted are far superior imo (much preferred over the others).

i never put a oil bolt gasket and i drove n tracked my cars for the past 6yrs never had a problem with it leaking

wow i remember you posting a vid a few weeks ago looking for one? did you finally get one? didnt see a build thread

scalpel wrote:wow i remember you posting a vid a few weeks ago looking for one? did you finally get one? didnt see a build thread

Haha yeah it's just on the DL for right now

370zforme wrote:

scalpel wrote:wow i remember you posting a vid a few weeks ago looking for one? did you finally get one? didnt see a build thread

Haha yeah it's just on the DL for right now

Come on....lets see it..