AE86 Manual Rack Q&A
Posted: Tue Aug 27, 2013 12:50 pm
Sorry guys, it's been too long since I dove back into this subject. I know this has been asked again and again countless time befores. I've had these parts sitting in my closet for over 3 years but before I start tackling my power->manual conversion process, I'd like to make sure I have all parts in order.
So a simple confirmation would be greatly appreciated. I'm pretty sure I have all the necessary and required correct parts.. but I digress. So.. the following parts are:
1x AW11 MR2 Manual Steering Rack
2x AE86 Power Steering Outer Tie Rods
2x AE86 Power Steering Inner Tie Rods
1x T3 Adapter Bushing
2x AE86 Power Steering Bracket (both left and right side - RH bracket will fit the T3 Adapter Bushing, while left side needs no mods since they are proven to fit)
1x MKIII Intermediate Shaft
1x AW11 MR2 Steering Shaft U-Joint
And thats the parts I have. Can anyone confirm I'm good to go?
Kudos,
Jay
So a simple confirmation would be greatly appreciated. I'm pretty sure I have all the necessary and required correct parts.. but I digress. So.. the following parts are:
1x AW11 MR2 Manual Steering Rack
2x AE86 Power Steering Outer Tie Rods
2x AE86 Power Steering Inner Tie Rods
1x T3 Adapter Bushing
2x AE86 Power Steering Bracket (both left and right side - RH bracket will fit the T3 Adapter Bushing, while left side needs no mods since they are proven to fit)
1x MKIII Intermediate Shaft
1x AW11 MR2 Steering Shaft U-Joint
And thats the parts I have. Can anyone confirm I'm good to go?
Kudos,
Jay