ARCambo wrote:What spec are the D2's you put on your GTi?

I've been offered some D2's, and am trying to find out more about them.

Sorry haven't been on in a while, unsure of the spec of the D2's, just says D2 Racing on the side.

jondee86 wrote:

NZ4age wrote:He is wanting to put in an aftermarket intake but wants to know what this is for??

That's the ISCV (idle speed control valve).

Cheers... jondee86

Cheers mate, that helps alot, will pass it on to my friend.

If you do go ahead with the 7age you could also try these guys, Barry specializes in 7age and 9age engine components http://www.mrpltd.co.nz/index.html

hello mate!this is the air temperature sensor!it sends signals to ecu by changing its resistance, as the temperature changing ! Cheers mate but the Air temp sensor is on the other side of the intake pipe, someone else of my 4age page has mentioned it could be something to do with cruise control the...

Hey guys, Friend of mine has recently bought AE92 Corolla Sprinter with 4age smallport. Engine is MAP sensored and air temp sensor is on the back side or intake. He is wanting to put in an aftermarket intake but wants to know what this is for?? Someone has mentioned previously it might be aux idle u...

Had one of these in my old one, great clutch and can take a bit of a beating, nice in the traphic too, don't get too much of a dead leg. http://japrace.com/products/Exedy-Sportstuff-Heavy-Duty-Clutch-Kit-Toyota-4AGE-20v.html , on blacktop 20v flywheel which is lighter than silvertop 20v, lighter fly...

Hello and good morning!have you relocate the battery?and where exactly?thanx Hey yes I have, relocated it to the right side of the boot/trunk in battery box secured to the boot floor with heavy duty well insulated cable from Auto electrician. Also ducting up from under the front bumper to the filte...

notice the amount of material removal between the top panel and the middle panel.... the bottom panel is once the taper has been changed, blended and mostly finished Thanks, that helps alot. Quite a considerable difference between top and bottom photo. Just looked through your many other photos on ...

.8mm gasket will add about 4/10 of a point, so from 10.3 to about 10.7. A half millimeter skim on the head will drop volume of chamber to about 34.75cc. That should bump compression a further 4/10s, so to about 11.1 to 1 Concerning porting.... having glanced @ the link you posted... a few of the pi...

http://www.csgnetwork.com/compcalc.html Bore 81 Stroke 77 Headgasket bore 82mm for stock Compressed HG thickness stock should be 1.2mm Combustion chamber volume is about 36 Deck should be very close to 0 It would be best if you can get piston dome measured directly off the piston because the number...

Hey everyone, Would anyone know what the compression ratio would be if using smallport 10.3:1 pistons, .5mm skim off head and .8mm TRD headgasket? Currently have 2nd gen 4age, Bigport T-VIS with red and black lettering on cam covers. Has 7 rib block with 9.4:1 compression ratio . Looking at doing a ...

Thanks

Hey everyone, glad to see club4ag is back up and running. This is my New Zealand 1988 AE92 Corolla Hatch with 2nd gen 7 rib 4age. Have owned it since 2004. Has been a daily driver up until 2010 when I started to modify it with the aim to eventually turn it into a track/sprint/hill climb club car Few...