copy
thanks

hi

i have a 97 corolla with tein coilovers, my bearing top plates are worn out
can i install original strut top mounts, will it fit with my coilovers??

thanksss
nate

the man has to be right, you must be using an hybrid 4age
get a timing light... no ?
it means you cannot take the notches as reference anymore, since the setup is fucked up
no?

check it out..

jeez are you sure injectors are firing? how comes/what means "because of cold start" is the engine running fine when its running? if you rev the engine anywhere below 3k its reacting normally? what happens when you say "is dying"? post a video... if the engine hardly keeps going ...

i would suspect deffective air sensor maf or map
or then maybe wrong distributor wiring or faulty ecu.. but i would be surprised the ecu

dunno..

man..

open up the ecu covers
the pinout is printed on the pcb itself... lulz

hope this helps

same, seen my bigport running with so much oil between the valve covers where the sparkplugs connect, it was a real joke
ran fine

man what is your engine, a redtop a blacktop or a silvertop?
you need the right ecu for the right engine..
then one connector is probably for the dash and the 1 must be for engine control

its pretty easy
where you in montreal?

jeez i bet you have air your your coolant system prime the hoses thousands of time and add every single freaking ml it will enter the radiator cap run the car a bit, stop it, prime the hoses (crush the bottom and top radiator hoses) again and add coolant again and again until you really really cant ...

cool thanks for the replies very appreciated ok i save my money for cams.. i want my 4age to kick ass and im sure it will end up horribly if i start "playing with things" eh 264 cams are good to work with stock ecu\injectors? good i have read that if i exceed 8mm in lift i will need more m...

ahoy i had a big port engine with t-vis that starved oil i hate myself and burnt seals. now i have a red top small port non t-vis swapped in, i see on Bill Sherwood's stock 4age page that the big port engine came with different intake/exhaust cams than those of the small port, hrm hrm can i take out...