morgan wrote:Sounds like a short somewhere. Do you need the zenki wiring diagrams? Message me your email and I can send them over.
I just PM you
morgan wrote:Sounds like a short somewhere. Do you need the zenki wiring diagrams? Message me your email and I can send them over.
davew7 wrote:Manual?
"Cannot find? it says invalid" That is very possible since I down loaded the manual about 15yrs ago. The only other ID is that the manual was release in 1997 and is manual MT2001.
davew7
oldeskewltoy wrote:with only a small jump after adding oil, I'd say you have a valve problem on cyl 3. Most often it will be a burnt, or bent exhaust valve[s].
davew7 wrote:You can down load the repair manual here. Search pbase.com/paulgreen/image/38984465
davew7
davew7 wrote:You can use anything for a push rod, such as a punch. As long as it be pressed against the M/C piston.
Davew7
davew7 wrote:It could possibly be the older rubber brake hoses, but I would still bet that you have air in the brake lines. Try using one of the vacuum brake bleeders.
Start at the rear longest brake line. Did you bench bleed the M/C for installing?
Davew7