![Image](http://s16.postimg.org/h6t9r94lx/20160329_164834.jpg)
Flange:
![Image](http://s13.postimg.org/inddox0hj/20160329_165710.jpg)
Collector:
![Image](http://s24.postimg.org/jswnmuro5/20160329_165616.jpg)
Downpipe collector flange:
![Image](http://s13.postimg.org/wpl2faks7/20160329_165800.jpg)
Downpipe flange by cat:
![Image](http://s18.postimg.org/66sbc8ekp/20160329_165829.jpg)
I have not installed it but after inspecting it, I would say the following:
1. Transitions are a lot better than in the ebay photos. Didnt expect them to be this good.
2. Flange that connects to cat is angled for some reason.
Here are some general specs they provide on the unit:
1. Connects to factory exhaust
2. O2 sensor on downpipe and at the collector
3. Flange fits 16v and 20v
4. 4-2-1 runner stainless steel with CNC mandrel bends
5. 1.65" runner tube
6. 2.5" downpipe
7. Equal Length runners
8. 2.5" V-Band Clamp
9. Does not come with any gaskets
Hope this helps everyone out whos looking to get a header.
![Wink ;)](./images/smilies/icon_e_wink.gif)