Silvertop purge valve pinout

[Army Fork]

I'm trying to connect this valve,



Using this pinout diagram,



but I can't find the correct connection. Any ideas?

[morgan]

you can find the proper pin-out here...
viewtopic.php?f=28&t=4906

[Army Fork]

I've been through that page several times and have all the info printed out. The pinout is not listed as far as I can tell, if you can see it point it out.

[morgan]

then finish up the the VVT solenoid, EVAP purge valve, and the Intake Air Temp. Sensor.

labeled EVAP. its the evap purge valve
also seen here...
http://padandwheels.com/mr2/blacktoppro ... rness.html

[Army Fork]

That's the blacktop setup, if you look at a silvertop ECU pinout you'll see no point for EVP.

[morgan]

ST & BT are the same pin-out. for some reason i cannot see your diagram in the 1st post, while im at work. not sure why. either way, their pin-out is the same, along with most other engine sensors between the two 20v's

[Army Fork]

No, actually the ST and BT don't use the same pinouts, I ran into that problem when I was tagging my plugs. The pinouts are significantly different

[morgan]

Ecu, yes. Sensor plugs, no.

You need the ST ecu pin outs? I looked at my thread, looks like some pics are missing. I can email the pages to you if you need

[Army Fork]

I would like that if you could, the pages I have seem to be lacking what I need. I'll PM you my email