I have a toyota marino with a silvertop swap and i do not have afm to have the car up and running so was thinkin of a map conversion. Did alot of reading but was very confused so decided to ask directly on a forum. If this issue has been addressed then please do direct me. I do have map and iat sensors and blacktop ecu (iam running auto atm). I read sumwea that blacktop oxygen sensor is needed ... didnt kno there was a difference between them so please help ...
What i need help with is :
-wea should i connect vaccum line for map
-how to wire map and iat to existing afm lug
-ecu pinouts ... dnt kno which ones to swap
Need assistance! ST 20v map conversion
Re: Need assistance! ST 20v map conversion
I haven't done this conversion, but there is some pretty legit looking info
in this thread... http://forums.club4ag.com/zerothread?id=35079
Pinouts can be found here... http://club4ag.com/technical_main.htm
For the MAP sensor, you can tap/tee into any line that connects the the
common vacuum rail. The line marked in orange in this pic would be most
suitable...
Cheers... jondee86
in this thread... http://forums.club4ag.com/zerothread?id=35079
Pinouts can be found here... http://club4ag.com/technical_main.htm
For the MAP sensor, you can tap/tee into any line that connects the the
common vacuum rail. The line marked in orange in this pic would be most
suitable...
Cheers... jondee86
The reasonable man adapts himself to the world; the unreasonable one
persists in trying to adapt the world to himself. Therefore, all progress
depends on the unreasonable man.
persists in trying to adapt the world to himself. Therefore, all progress
depends on the unreasonable man.