Hello,

Can someone tell me what the gasket with number 1,2,3 and 4 are for? Thanks

is this for a 20v or a 16v?

is 2 and 4 the same size? these could be the fuel hose to fuel rail seals. 1 is for the water pump backing plate o ring seal. 3 i dont know what that is for

Could 1 be the oil dipstick tube? It looks kind of small to be the water pump backing plate, at least comparing it to the valve stem seals. 2 & 4 do look like crush washers for the fuel hose banjo bolt or the cold start injector.

Is 3 made of papery stuff?

Rogue-AE95 wrote:Could 1 be the oil dipstick tube? It looks kind of small to be the water pump backing plate, at least comparing it to the valve stem seals. 2 & 4 do look like crush washers for the fuel hose banjo bolt or the cold start injector.

Is 3 made of papery stuff?

yea i was originally thinking the dipstick tube too so yea it could be.

Hello,

The gasket kit it for the 20V indeed.

I think nr1 has to be the oil dipstick tube then (size is about 13.7mm (0,5314 inch). The water pump o-ring has been used already I think the one for the waterpump is brown and about 40 mm (1,5748 inch).

2 and 4 are the same size about 16mm (0,6299 inch).

3 is a sort of paper thing yes and it meausures 21mm (0,8267 inch)

Hello,

The gasket kit it for the 20V indeed.

I think nr1 has to be the oil dipstick tube then (size is about 13.7mm (0,5314 inch). The water pump o-ring has been used already I think the one for the waterpump is brown and about 40 mm (1,5748 inch).

2 and 4 are the same size about 16mm (0,6299 inch).

3 is a sort of paper thing yes and it meausures 21mm (0,8267 inch)

Are those measurements the outside diameter?
1. Dipstick
2. Fuel banjo
3. Drain plug
4. Fuel banjo

I've meausured the outside diameter yes.

No wonder i didn't recognise the drain plug gasket, cause i bought a new oil pan with the plug already in it.

Thanks all.