Stock header replacement group buy feeler (FWD & MR)
Posted: Wed Sep 11, 2013 7:02 am
I have had a couple people come to me looking for a new header but the price for a one off is a little hard to swallow.
I thought I'd put it out there and see if others were interested.
For one header the cost would be right around $325
If we could get 5 people I could bring it down to about $280
If we could do 10 I could probably get them under $250.
I would make a jig off a 16V mani and one off a 20V mani. Both would be tubular very similar to the 20v mani but you could choose flanges and flange location to bolt up to either.
I would use the same 11 gauge tubing that I use for my turbo manifold so this should be the kind of manifold you pass down to your grand kids.
I can do EGR bungs and O2 bungs where needed per the customer.
And of course there will be a few options for the upsell.
Stainless steel for those with deep pockets
Ceramic coatings for those who want added thermal barrier, rust protection and a little added sexy.
I thought I'd put it out there and see if others were interested.
For one header the cost would be right around $325
If we could get 5 people I could bring it down to about $280
If we could do 10 I could probably get them under $250.
I would make a jig off a 16V mani and one off a 20V mani. Both would be tubular very similar to the 20v mani but you could choose flanges and flange location to bolt up to either.
I would use the same 11 gauge tubing that I use for my turbo manifold so this should be the kind of manifold you pass down to your grand kids.
I can do EGR bungs and O2 bungs where needed per the customer.
And of course there will be a few options for the upsell.
Stainless steel for those with deep pockets
Ceramic coatings for those who want added thermal barrier, rust protection and a little added sexy.