If anyone has a big port head at hand, would you be kind enough to measure the length of the intake port. A rough but close measurement from the port opening to the top of the valve seat.
Im currently making a new intake and the only big port head i have is on the car.
Port Request
-
- Club4AG MASTER
- Posts: 2084
- Joined: Sun Jan 13, 2013 1:18 pm
- Contact:
Re: Port Request
Is it bad that I have the better part of a 4AGE in my bedroom closet?
I'd say about 50mm from the center of the valve to the center of the port.
I'd say about 50mm from the center of the valve to the center of the port.
- oldeskewltoy
- Club4AG MASTER
- Posts: 2184
- Joined: Wed Jan 09, 2013 4:44 pm
- Location: Portland, Oregon
Re: Port Request
length across the roof of the port just shy of 4"... length along the floor of the port 2.4"
OST Cyl head porting, - viewtopic.php?f=22&t=300
Building a great engine takes knowing the end... before you begin
Enjoy Life... its the only one you get!
Building a great engine takes knowing the end... before you begin
Enjoy Life... its the only one you get!
-
- Club4AG Enthusiast
- Posts: 134
- Joined: Thu Jan 24, 2013 9:07 am
Re: Port Request
oldeskewltoy wrote:length across the roof of the port just shy of 4"... length along the floor of the port 2.4"
Perfect, thank you very much
-
- Club4AG MASTER
- Posts: 2084
- Joined: Sun Jan 13, 2013 1:18 pm
- Contact:
Re: Port Request
BTW I sell flanges if you are looking for one.
http://matrixgarage.com/store/4age-fabrication-supplies
http://matrixgarage.com/store/4age-fabrication-supplies