assembled and running DIYAutotune DIYPNP for 4AG $450

[burdickjp]

I switched to an MS3, so I am selling my DIYPNP. It was running my AE86 very well on all stock sensors, just need to run a vacuum line to the manifold for the MAP sensor.

[ritz]

damn it, bought mine two weeks ago.

This is a great system, and a great price.

[Shadelyfe_Blvd]

I switched to an MS3, so I am selling my DIYPNP. It was running my AE86 very well on all stock sensors, just need to run a vacuum line to the manifold for the MAP sensor.

Where are you located? Number or email to reach you at?

[burdickjp]

Where are you located? Number or email to reach you at?

You have a PM.

[GodLovesUgly]

still for sale?

[makibaka]

for 16v?

[c4ptiv3]

Cash in hand if for a 16v.

[quietskaterguy]

is this still for sale?

[morgan]

I might be interested if this is from your 20v

[burdickjp]

Updated first post with pics.

[burdickjp]

I'd really like to see this helping someone rather than sitting on my shelf.

[makibaka]

I'm very interested if it's for a 20v. Contact info? PMs don't work for me for some reason.

[makibaka]

Unless my tired eyes and cracked phone screen are deceiving, it looks like a yellow 42 pin connector for a 16v?

[burdickjp]

Unless my tired eyes and cracked phone screen are deceiving, it looks like a yellow 42 pin connector for a 16v?

Yes. It is for a 16v big port. It could be used to run a 20v if you did some connector swapping on the engine end. This would let you keep most of the original 16v harness. That was actually my original intention before I ended up going with the Megasquirt 3. Considering the code advancements with MS2Extra, I probably wasted my money, but the car is already wired, so this is for sale.

[burdickjp]

I want this gone. Make an offer.

[makibaka]

I'm still very interested. Do you have a tune to run it for a 20v?

What would it take to install a 76 pin connector (i.e. new case, resolder, etc.)? I already spent some coin on a tweak 20v harness so I'd like to use that.

[burdickjp]

I'm still very interested. Do you have a tune to run it for a 20v?

What would it take to install a 76 pin connector (i.e. new case, resolder, etc.)? I already spent some coin on a tweak 20v harness so I'd like to use that.

How are you planning on running your ignition? At this point it may be better to just build you a new DIYPNP with the features you want.

[makibaka]

I'm planning to run 1NZ coils (tweak harness has leads for both COP & stock ignition). The car is my daily so I only plan to run a mild state of tune (header, exhaust, intake) in the long term. I guess I'm looking for a more solid solution to run COP since the stock distributor & ignitor continue to have clearance issues for my application (vintage british car).

[burdickjp]

Original is sold