***Illegal Garage Parts***

[Illegal_Garage]

Still have 212mm clutch/flywheel combos?

I can put something together for you

Send me an email
Thank

Max

[Mr.Fujiwara]

Emailed!

[mccune05]

emailed

[Illegal_Garage]

Thanks guys

Max

[Illegal_Garage]

To the top
Thanks for looking

Max

[supraman10]

can you make a lightweight flywheel in the 6 bolt pattern of the 4AFE/7AFE crank in either 212mm or 224mm with the starter ring of a 4AGZE?

[Illegal_Garage]

I do t think so
Only 200mm available currently

Max

[solo2go1]

Is this the 1 piece drive shaft you sell that's on ebay?

http://www.ebay.com/itm/Group-A-Toyota- ... 1072658774

[Illegal_Garage]

That's not me

It says Group A
I think that is the name of their "shop"

No mention of warranty on that eBay add

I prefer to sell off of eBay
Currently eBay + PayPal fees adds up to 11%
11% savings goes straight to the buyer

I give 1 year unlimited warranty and life time on balancing

Max

[solo2go1]

Ok thanks, good to know.

[Illegal_Garage]

TTT

Max

[shafted]

Max can you quote how much it is for a 1-piece driveshaft? thanks!

[Illegal_Garage]

Yup still $400 shipped anywhere in the USA

Max

[gaijindrift]

Max is awesome!

[Illegal_Garage]

Thanks!

[20vCelica]

Hi interested in aw11 MR2 steering rack for my ae86.Let me know How much shipped to 92119. THANKS

[Illegal_Garage]

I don't think I have any steering racks left
You should be able to get these from rock-auto though

Max

[Illegal_Garage]

Still selling parts here
Thanks guys

Max

[ToeKnee805]

bump for you dude, running on my 2nd illegal garage clutch and i love it

[7locost]

Max,

Do you have or know of anyone making/selling a 20V dizzy cover plate? Am running Ford EDIS and removed the stock dizzy. The cover I made leaks a little.

Larry - mbnlwj3@gmail.com

[wattsupbr86]

looking for somthing like this ?
http://shop.battlegarage-rs.com/products/sq-20v-16v-4age-3sgte-distributor-block-off-cap

[Buscarlo]

I pmed you about a clutch and flywheel. Let me know! thanks!

[Ivan]

Email sent Max

[EddieNanakase]

Hi Max, after a very long time I think it's finally time to get that one piece driveshaft. I'm using a
W58 transmission on my AE86. So the measurement from the differential pinion flange to the W58
output shaft is approximately 50.2 in. I remember you asked me for two measurements, one
measurement is with the vehicle jacked up with the rear suspension/differential hanging and the
other measurement is with the AE86 standing on the ground. The thing is, I have coilovers in the
front and in the back. The differential/suspension doesn't hangs even when the rear has been
suspended with jack stands on the chassis (jack stands not placed on the differential). The
coilovers are height adjustable.

[Illegal_Garage]

I am always available by email or text
maxfrommisawa@aol.com or 408-420-6003

Thanks