Ogiptech bellhousing?

cliqwe
Club4AG Enthusiast
Posts: 106
Joined: Thu Jan 10, 2013 10:29 pm
Location: Riverside, CA

Ogiptech bellhousing?

Postby cliqwe » Tue May 26, 2015 2:10 pm

Does anyone have any experience with their 4age to w58 bellhousings? Wondering if they had any issues or if there's anything to watch out for in general with these kinds of bellhousings? Was looking at Niteparts as a comparison as they seem to have quite a bit of suport from the community... Ogiptech one is a little cheaper though, I think it's coming from the Phillipines While the other is based in New Zealand.

GZE_RA21
Club4AG Enthusiast
Posts: 106
Joined: Sat Jan 16, 2016 6:19 pm
Location: San Clemente, California
Contact:

Re: Ogiptech bellhousing?

Postby GZE_RA21 » Fri Feb 12, 2016 5:25 pm

I personally bought the ogiptech bellhousing and it works great! Very satisfied and Remy is a super cool and very helpful dude. I mated my bellhousing to the larger 225mm 4AGZE clutch pressure plate and flywheel and with a little bit ground down on one or two edges it worked with no problem, i dont think i would have had to grind it down but i just wanted to be safe. I'll admit i was skeptical at first because he doesn't offer package tracking but i got my bellhousing in like a week and it works great, nothing like that buttery smooth W58!