I picked up a set few months ago.
Been wanting to install it but, before I start drilling holes and such....
can any of you CUSCO Tribar gods chime in on how I should go at this....
and point me in the correct path?
thx mucho in advance fellas!
this is the rear tribar in question:
Help plz CUSCO Rear Tribar Install Help plz
- idreamofdrifting
- Club4AG MASTER
- Posts: 1122
- Joined: Fri Jan 11, 2013 2:35 pm
Re: Help plz CUSCO Rear Tribar Install Help plz
I would fully assembled it and set it in the car to mark where you need to drill. Measure twice drill once.
Eric'sFreeAE86 from the old site
Knockoff Crew member #0001
Knockoff Crew member #0001
- idreamofdrifting
- Club4AG MASTER
- Posts: 1122
- Joined: Fri Jan 11, 2013 2:35 pm
Re: Help plz CUSCO Rear Tribar Install Help plz
carbd7age wrote:I would fully assembled it and set it in the car to mark where you need to drill. Measure twice drill once.
Sounds good Eric, I will do that!
Re: Help plz CUSCO Rear Tribar Install Help plz
quick tip. for the piece that mounts to the floor, if you look at the spot from under the car, it goes in between a crossmember and some fuel lines. BE CAREFUL!
- idreamofdrifting
- Club4AG MASTER
- Posts: 1122
- Joined: Fri Jan 11, 2013 2:35 pm
Re: Help plz CUSCO Rear Tribar Install Help plz
mandm177 wrote:quick tip. for the piece that mounts to the floor, if you look at the spot from under the car, it goes in between a crossmember and some fuel lines. BE CAREFUL!
THANK YOU! I was wondering about that too. Again thx for the very important tip!
Re: Help plz CUSCO Rear Tribar Install Help plz
I would think some large washers would help as well to prevent the bolts from being pulled through the sheet metal.
- idreamofdrifting
- Club4AG MASTER
- Posts: 1122
- Joined: Fri Jan 11, 2013 2:35 pm
Re: Help plz CUSCO Rear Tribar Install Help plz
ga_goosh wrote:I would think some large washers would help as well to prevent the bolts from being pulled through the sheet metal.
excellent tip as well Sean! thx brother!