I have some Omori gauges laying around and since my dash gauges are acting funny I figured I would swap them out. The water temp is easy as it goes inline of the water hose. Now it is figuring out which hose to run it with, the top hose near the cap or ?? Now the fun is the oil pressure is there a place to connect without getting a sandwich plate or should I just get one and run them that way?

Any suggestions would be helpful. I searched before I asked on both forums.

I think the Omori water temp sensor will screw into the oem gauge sensor hole.
You could remove the oem oil pressure sensor (to the left of the oil filter) and run the omori hose to that using an adaptor.

thanks that is what I was thinking also.