AE86 Engine Ground Diagram?
AE86 Engine Ground Diagram?
Is there a diagram for where the grounding points are in the the engine bay and on the tranny? I took mine apart and cant remember where they go D:
- HASport AE86
- Club4AG Expert
- Posts: 201
- Joined: Mon Jan 14, 2013 6:09 pm
- Location: Loma Linda, CA
Re: AE86 Engine Ground Diagram?
Doesn't really matter where on the trans, you can use one of the rubber mount bolts or the clutch slave bolts.
You should have:
Engine block to driver frame rail
Cylinder head to firewall
Trans to firewall or bottom chassis
You should have:
Engine block to driver frame rail
Cylinder head to firewall
Trans to firewall or bottom chassis
SwangBiz Corolla Chassis Parts and F20/F22C/4AGE Wiring Services
(we build stuff, I solder wires, we race corollas, then we get drunk)
Proud Supporter of JSPfab.com, BattleGarage, and Solo8 LED Solutions
(we build stuff, I solder wires, we race corollas, then we get drunk)
Proud Supporter of JSPfab.com, BattleGarage, and Solo8 LED Solutions
Re: AE86 Engine Ground Diagram?
Oh hey thanks man, always being so helpful ;D
- HASport AE86
- Club4AG Expert
- Posts: 201
- Joined: Mon Jan 14, 2013 6:09 pm
- Location: Loma Linda, CA
Re: AE86 Engine Ground Diagram?
cliqwe wrote:Oh hey thanks man, always being so helpful ;D
More fixed corollas=More driving buddies.
SwangBiz Corolla Chassis Parts and F20/F22C/4AGE Wiring Services
(we build stuff, I solder wires, we race corollas, then we get drunk)
Proud Supporter of JSPfab.com, BattleGarage, and Solo8 LED Solutions
(we build stuff, I solder wires, we race corollas, then we get drunk)
Proud Supporter of JSPfab.com, BattleGarage, and Solo8 LED Solutions
Re: AE86 Engine Ground Diagram?
"you can use one of the rubber mount bolts "
Ah, yes, as long as you don't try to connect the ground strap to the isolated "same" side of a mount.<G> You really could just wind up grounding the block to itself, instead of the tranny or body, if you didn't know the bolts don't go straight through, no?
Ah, yes, as long as you don't try to connect the ground strap to the isolated "same" side of a mount.<G> You really could just wind up grounding the block to itself, instead of the tranny or body, if you didn't know the bolts don't go straight through, no?
-- Original owner, 1985 GT-S
-
- Club4AG Expert
- Posts: 297
- Joined: Thu Aug 15, 2013 4:17 pm
Re: AE86 Engine Ground Diagram?
Question: I'm trying to from reading the above I believe this ground should attach to the tranny. The wire was 'free' when I purchased the car and would ideally like to place it where it originally belonged. Can anyone assist? Thanks -Aaron
-
- Club4AG Regular
- Posts: 18
- Joined: Mon Sep 16, 2019 11:40 am
Re: AE86 Engine Ground Diagram?
Ground strap to transmission bellhousing.