Blacktop IAT?

tlea
Club4AG Regular
Posts: 32
Joined: Fri Aug 03, 2018 3:34 am

Blacktop IAT?

Postby tlea » Thu Nov 07, 2019 4:53 am

On a different topic I am setting up my wiring harness for blacktop. This is going in a Morris minor and am using Tweaked universal harness w/ Elite 750 ECU. I have one plug that goes to IAT? (Assume I know very little about 20v engine management systems) I was told IAT is in airbox but I have no place in mine where one is located? It is factory airbox. Does anyone have a picture of what it looks like and where it goes?

Disable adblock

This site is supported by ads and donations.
If you see this text you are blocking our ads.
Please consider a Donation to support the site.


User avatar
jondee86
Moderator
Posts: 2469
Joined: Fri Jan 11, 2013 10:21 pm
Location: Wellington, New Zealand

Re: Blacktop IAT?

Postby jondee86 » Sun Nov 10, 2019 1:49 pm

The AE111 IAT should look like this...

Image

And the factory manual says that there is a "cord" connected to the airbox
at the intake end in the position I have marked. As I can't think of anything
else with a cord that would plug into the airbox, I'm going with IAT sensor.

Image

The sensor likely pushes into a rubber grommet fitted into a hole in the
airbox cover, and is retained by the small barbs on the outside of the sensor.

Cheers... jondee86
The reasonable man adapts himself to the world; the unreasonable one
persists in trying to adapt the world to himself. Therefore, all progress
depends on the unreasonable man.

tlea
Club4AG Regular
Posts: 32
Joined: Fri Aug 03, 2018 3:34 am

Re: Blacktop IAT?

Postby tlea » Tue Nov 12, 2019 4:14 am

That is perfect, thank you

Disable adblock

This site is supported by ads and donations.
If you see this text you are blocking our ads.
Please consider a Donation to support the site.



Return to “TECH: 4A-GE ENGINE”

Who is online

Users browsing this forum: No registered users and 1 guest